Carrol Touch Modular Flat Panel Specifications download pdf (Page 105)

Chapter 7 - CTKERN CARROLL TOUCH

7-18 Touch System Programmer’s Guide

After completing these four steps, the third Other Video Mode screen

appears as shown in Figure 7-11.

Figure 7-11. Calibration Other Video Mode Screen #3

When the target is touched, the number displayed above the prompt

counts down until it reaches 0. You are then prompted to remove your

finger. This process is repeated for the lower right corner, and the Main

Menu screen reappears.

Edit Entry

Press the M key to display the Manual Edit Menu screen, as shown in

Figure 7-12. The screen displays the calibration parameters for the

selected calibration table entry, along with the list of menu options.

You may use the keys listed in the Manual Edit Menu to edit the

calibration table entry parameters. When the parameters are edited as

desired, and you exit the manual edit menu screen, the Main Menu

screen reappears.

Delete Entry

Press the D key to set all calibration parameters for the selected

calibration table entry to 0. The Main Menu screen reappears.

Touch the tape that was previously

applied to the upper left corner using

inserting it straight into the

only one finger, inserting it straight

into the screen. Hold your finger in

place until you are prompted to remove it.

Press any key to abort calibration.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 273 274

No comments

Carrol Touch Modular Flat Panel Specifications Page 105